iCore 5 vs iCore 7 ?

Started by netn00b, Apr 28, 2012, 21:50:20

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Gary

Quote from: Technical Ben on Apr 30, 2012, 23:20:21
Sounds similar to my AMD chip.  ;D
Hot enough to fry an egg, but without the Intel i7 performance you mean  ;)
Damned, if you do damned if you don't

Gary

In all seriousness though Moore's law is popping its head up again as to how long silicon can keep advancing to physics gets in the way http://www.theregister.co.uk/2012/04/30/moores_law_ends/
Damned, if you do damned if you don't

Glenn

I think it slowed a lot recently, the bigger jumps in processing speed seems to be increasing the number of cores per chip
Glenn
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.

Steve

Although doesn't Moore's law more specifically relate to the number of transitors per chip?
Steve
------------
This post reflects my own views, opinions and experience, not those of IDNet.

Gary

Quote from: Steve on May 01, 2012, 08:38:56
Although doesn't Moore's law more specifically relate to the number of transitors per chip?
I think that's why Intel went for the 3D structure in increase that, but still there is a limit.
Damned, if you do damned if you don't

Technical Ben

#30
Quote from: Glenn on May 01, 2012, 08:35:34
I think it slowed a lot recently, the bigger jumps in processing speed seems to be increasing the number of cores per chip
That's not down to tech but demand AFAIK. It's more about power consumption currently. Granted, you can always find a use for more GHZ, but most people don'tneed it for word or internet browsing. So the market is swinging over a bit. However, things like 3d chips might keep mores law going a little longer.  :)

[edit]
As Gary said! :D
It might be demand and the market more than technology and science that drives the speed of the PC.
I use to have a signature, then it all changed to chip and pin.

pctech


Glenn

Take a look at the 2nd post.  ;)
Glenn
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.

pctech


Glenn

Sorry the 2nd post on this page, #26
Glenn
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.

pctech

Sorry.

didn't read the thread through.

Technical Ben

There was always an upper limit (physically) to how small you can make something. However, then you just keep making it bigger or more efficient/simple and keep Mores Law going from there. It's a bit like a car engine. There is an absolute limit to how many mile per gallon you can do. After that you're throwing out the spare wheel and mother in law to save fuel or getting a smaller car.
I use to have a signature, then it all changed to chip and pin.

pctech

Some folks might prefer to use the mother-in-law AS a spare wheel  ;D

gizmo71

Quote from: Technical Ben on May 01, 2012, 18:56:25
After that you're throwing out the spare wheel

Don't have one of those - just a can of gunk and a compressor.
SimRacing.org.uk Director General | Team Shark Online Racing - on the podium since 1993
Up the Mariners!