Bad connection

Started by dunkers, Mar 01, 2008, 01:39:58

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Rik

I'll never be able to discuss noise margin in the same way again. :)
Rik
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.

Inactive

Of course the Fiat will break down and jam the tunnel, still Fiat + Italy = Tiscali... ;D
Anything and everything that I post on here is purely my opinion, it ain't going to change the world, you are under no obligation to agree with me, it is purely my expressed opinion.

Mytheroo

I actually own the bad Fiat  :blush:

good news is it has fitted in all tunnels so far  :thumb:
There are 10 kinds of people, those who understand binary and those who don't.

Gary

Quote from: Mytheroo on Mar 04, 2008, 16:04:59
I actually own the bad Fiat  :blush:

good news is it has fitted in all tunnels so far  :thumb:
they fit in skips to  ;)
Damned, if you do damned if you don't

Inactive

Anything and everything that I post on here is purely my opinion, it ain't going to change the world, you are under no obligation to agree with me, it is purely my expressed opinion.

Mytheroo

Quote from: Inactive on Mar 04, 2008, 16:03:52
Of course the Fiat will break down and jam the tunnel, still Fiat + Italy = Tiscali... ;D

Very Truissimo. Luckily I do all the work on it myself, which keeps me in full time employment  ;D
There are 10 kinds of people, those who understand binary and those who don't.

Inactive

Quote from: Killhippie on Mar 04, 2008, 16:05:51
they fit in skips to  ;)

They not only fit in skips, they are skips when upturned..  :out: :duck:
Anything and everything that I post on here is purely my opinion, it ain't going to change the world, you are under no obligation to agree with me, it is purely my expressed opinion.

Inactive

Quote from: Mytheroo on Mar 04, 2008, 16:07:27
Very Truissimo. Luckily I do all the work on it myself, which keeps me in full time employment  ;D

;D :thumb:
Anything and everything that I post on here is purely my opinion, it ain't going to change the world, you are under no obligation to agree with me, it is purely my expressed opinion.

Rik

Rik
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.

dunkers

Hmmm... we happen to have a Passat and a Civic here. Not sure which goes with what line, though.

Spoke with support who say my SNR was 9db (which it was at the time) so therefore my target must be set to that. Didn't stop the line dropping, but I don't know what the SNR was at that time. Hmmm.

Rik

Did they test the line?
Rik
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.

dunkers

BT or support? I don't actually know either way.

Rik

Support would normally have tested the line to see if they could identify a problem. What did you actually ask them?
Rik
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.

dunkers

Me:

QuoteHi, I'm having intermittent problems with my connection. Could I have the down SNR pinned at 9db for a while, please, so I can rule this out as a potential cause/fix. I understand that this could reduce my bandwidth.

Them:

QuoteYour SNR margin is already at 9db, suggesting this is the current target
for your circuit.

Rik

Ah, OK. It might be worth going back and reporting the instability, asking them if they could take a look at the line for you (a woosh test).
Rik
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.

dunkers

Yes, you're right. However, I didn't want to start an actual investigation because when it inevitably gets to BT needing to come out they can't do that until next month (for access reasons here, rather than them). It would be tricky to sort of put it on hold if/when it gets to that point, so I was holding off until I can follow through (fnarr). Also, it seems  reasonable to think the same or similar problem afflicts both lines, so I'll probably need to coordinate Enta and IDNet to have 'em both looked at by the same engineer.

Rik

Sounds like a plan.
Rik
--------------------

This post reflects my own views, opinions and experience, not those of IDNet.